cm2mtk2 not open

[00AD1C25DF]

hello team

iafter many trys of unistall and install its open and also reset frp infinix hot 50i x6531 successfully

i try ro open it again not open iam tired of reinstall it i need final Solution

CM2MT2 v2.99 Boot [DA] Factory v7
Port: BROM + PL; Force BROM: 0; USB High-Speed: On
DA Key: custom; LSLA: Off; Auto-EMI: On
Power device Off and connect cable now
Remember Volume Up/Down or Test-Point
Waiting for device...
[ PRELOADER #27 ] MediaTek PreLoader USB VCOM (Android) (COM27) 0E8D:2000
Waiting for boot Ack...
Handshake... Ok
MT6768 HWs: 8A00 HWv: CA00 HWc: 0707 SWv: 0000 Evo: 0000 Helio Talbot|P65|G85 Type: [Raphael]
Sec: 0x0005 SBC+SDA; BROM/BL ver: 0xFF/0x03 [PRELOADER]
SoC support by Boot [FF] FireFly: Yes
MEID: 1F01CD5835D069E1CC950E59AA8D0572
SOCID: E1003CCCA9453569150D56DC9EBD5B929BE0F5960BE3BF4BF39E094714A3C9E0
[15946d6d] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\MTK_AllInOne_DA_v2401.dec5.39b336e8.bin
[bd322c2c] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\auth_sv5_24.auth
Looking for bootcode... Ok
DA Vendor: tran(5)
Sending DA1...
port reset(1)... Ok 19 sec
port reset(0)... Ok 1 sec
Reset interface...
[ PRELOADER #27 ] MediaTek PreLoader USB VCOM (Android) (COM27) 0E8D:2000
Waiting for boot Ack...
Handshake... Ok
MT6768 HWs: 8A00 HWv: CA00 HWc: 0707 SWv: 0000 Evo: 0000 Helio Talbot|P65|G85 Type: [Raphael]
Sec: 0x0005 SBC+SDA; BROM/BL ver: 0xFF/0x03 [PRELOADER]
SoC support by Boot [FF] FireFly: Yes
MEID: 1F01CD5835D069E1CC950E59AA8D0572
SOCID: E1003CCCA9453569150D56DC9EBD5B929BE0F5960BE3BF4BF39E094714A3C9E0
[15946d6d] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\MTK_AllInOne_DA_v2401.dec5.39b336e8.bin
[bd322c2c] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\auth_sv5_24.auth
Looking for bootcode... Ok
DA Vendor: tran(5)
Sending DA1...
port reset(1)... Ok 19 sec
port reset(0)... Ok 1 sec
Reset interface...
[ PRELOADER #27 ] MediaTek PreLoader USB VCOM (Android) (COM27) 0E8D:2000
Waiting for boot Ack...
Handshake... Ok
MT6768 HWs: 8A00 HWv: CA00 HWc: 0707 SWv: 0000 Evo: 0000 Helio Talbot|P65|G85 Type: [Raphael]
Sec: 0x0005 SBC+SDA; BROM/BL ver: 0xFF/0x03 [PRELOADER]
SoC support by Boot [FF] FireFly: Yes
MEID: 1F01CD5835D069E1CC950E59AA8D0572
SOCID: E1003CCCA9453569150D56DC9EBD5B929BE0F5960BE3BF4BF39E094714A3C9E0
[15946d6d] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\MTK_AllInOne_DA_v2401.dec5.39b336e8.bin
[bd322c2c] C:\InfinityBox\CM2MT2\boot\Tecno\2024-08\auth_sv5_24.auth
Looking for bootcode... Ok
DA Vendor: tran(5)
Sending DA1...
port reset(1)... Ok 20 sec
port reset(0)... Ok 1 sec
Reset interface...
[ PRELOADER #27 ] MediaTek PreLoader USB VCOM (Android) (COM27) 0E8D:2000
Can't open port
Change USB cable and USB port. Latest SoC drivers or PC REBOOT may helps
SoC drivers: MediaTek PreLoader USB VCOM (Android) v3.0.1512.0
Verify [DA] data... Ok 797 us
Stop [Job 24528204] Read FW v2.99 3 min 4 sec
Start META FRP Tecno/Infinix/iTel 2025 v2.99
Power device Off and connect cable now
To enter META mode device must be able to Power On well!
Waiting for device...
[ PRELOADER #27 ] MediaTek PreLoader USB VCOM (Android) (COM27) 0E8D:2000
Waiting for boot Ack...
Waiting for boot logo... Ok 31 us
port reset(1)... Ok 1 sec
port reset(3)... Ok 9 sec
META Ok
ping... nOk 3 sec
Switch protocol [AP]... Ok 1 sec
Boot done 17 sec
AP SoC: MT6768
AP SW ver: alps-mp-s0.mp1.rc-V16.49_reallytek.wtn.s0mp1rc.k61v1.64.bsp_P14
AP SW time: Wed Sep 10 22 53 14 CST 2025
FRP... Ok
Device should reboot in 30 sec. If it is not - power it On by Power key
1. Power device On
2. Be sure it works well
3. To finalize process make [Restore factory safety config]
Stop 28 sec
SoC supported: MT6735/T;MT8735A/MT6737M/MT6735G/MT6753/MT3967/MT6763/MT6739/MT6731/MT8765/MT6768/MT6769/MT6761/MT6762/MT3369/MT8766/MT8166/AC8257/AC8258/AC8259/MT6765/MT8768t/MT6771/MT8385/MT8183/MT8666/MT6575/MT6577/MT8317/MT6580/MT6752/MT8127/MT3367/AC8227L
Load devices from server? No

Start Connect v2.99

=== DongleManager [Infinity] v1.94 [11/10/2025 10:09:17 ã] ===
Searching...
Card-Reader: Alcorlink USB Smart Card Reader 0
HWID: 000025DF12534082
Box/Dongle found: Infinity-Box/Dongle [CM2]
Serial No (S/N): AD1C25DF
Firmware version: 0168.02
"UK Edition" status: On
Last launched Application: 0032 v.0168
=> Activations:
- 00: Infinity-Box/Dongle [CM2] v0168
=> Options:
- Infinity-Box/Dongle [CM2]

[00AD1C25DF]

not open till i reinstall it

ok

another issu when i try to write my username and password it gives me wrong


User break Connect v2.99 5 sec
<AD1C25DF> wrong username
Access denied [0x01]
<AD1C25DF> wrong username
Access denied [0x01]

User break Connect v2.99 5 sec
<AD1C25DF> wrong username
Access denied [0x01]
<AD1C25DF> wrong username
Access denied [0x01]

it give AD WITHOUT 00 BEFORE IT

also need if my mtk drivers is the last version or not

[00AD1C25DF]