Page 1 of 1

DEVICE <-> FIRMWARE PartTable mismatch

Posted: 09 Feb 2022, 21:48
by Support
DEVICE <-> FIRMWARE PartTable mismatch

If you find such message at flash any device :

Image

In most cases it means that something is wrong
If device is already dead - just skip it

Otherwise, it may produced by region change (f.e. Xiaomi ) or other HW revision (other models)

Autobackup is now enabled by default so after device flashing - check it's state and if BaseBand or security gone - next ones button:

Image

Will restore just software-version indepedent security items.

Re: DEVICE <-> FIRMWARE PartTable mismatch

Posted: 09 Feb 2022, 21:49
by Support
That message at memtool operation should indicate devices, where emmc can be swapped even with programmed rpmb key. ( ONLY SWAP BETWEEN DEVICES WITH SAME MESSAGE IN LOG!!! )

Image