#CM2SP3 [ADL] boot mode

[Support]

[ADL] is a special connection way.
It may works for some models and it depends on sec patch or manufacturer.



in some cases [ADL] may be useful due to TP is not required for it but the same mode may need TP for [FF] or [FDL].

If you have an issue with [ADL] connection you should use [FF] or [FDL] boot mode as before, probably with Test-Point

How to connect via [ADL]
1. Power phone Off
2. Select [ADL]
3. Select [mode-a] or [mode-b] - try both one by one in case of connection fault
4. Click to [Connect]
5. And connect cable to phone
Now wait. If device supported it will be connected otherwise you will see error messages.