#CM2SP3 Tool

Post Reply
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

#CM2SP3 Tool

Post by Support »

[FDL] boot - Default/standard boot mode.
FireFly [FF] boot - Advanced protocol with many features but in some cases it' may be slow. Consider to use [FDL] boot for firmware Read/Write.

How to use CM2 SP3 Tool. See HERE list of versions and functions.

For devices with UFS flash chip use [FDL] mode or use PAC file (latest version) as loader.
If no luck - wait, sw will be updated in some time

1. Select SoC/CPU or model
2. Click to [Connect]

Image

3. Do the Job. You can do several operations one-by-one, it's called [LiveBoot mode]

Image

4. Click to [Disconnect] to Reboot or Power device Off

Image
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

Re: #CM2SP3 tool

Post by Support »

How to use PAC of FDL1/FDL2 files with CM2

Image
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

Re: #CM2SP3 tool

Post by Support »

How to use CM2 [EXTCSD] Read/Write and [RPMB] read/Write

Image
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

Re: #CM2SP3 tool

Post by Support »

How to use CM2 [MMC EOL Reset]

[MMC EOL Reset] function may extend lifetime and repair faulty EMMC chip.
You can try this option if device comes to permanent bootlop and lifetime report says EMMC is out of order.
There is no guarantee that it helps but in case of completely dead EMMC you lost nothing anyway.
REMEMBER: all data will be lost after this operation!

Image
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

Re: #CM2SP3 tool

Post by Support »

How to use CM2 [AppTool]

1. Click to [Connect]
2. Go to [AppTool]
3. Click to [Load Apps]

Image

4. Make App On [v] or Off [ ]
5. Click to [Apply]

Image
Support
Posts: 4177
Joined: 19 Oct 2011, 20:27
Contact:

Re: #CM2SP3 Tool

Post by Support »

Image
Post Reply